Throttle Interface
(POTBOX)
The Throttle Interface (Potbox) uses a mechanical plunger with an optical sensor to provide the command
signal to the Power Center. The Potbox fits behind the gas pedal and mounts either by Hook & Loop
fastener (hook is on the Potbox) or with L brackets. A window on the side of the case is used to view the
status LED during the initial setup process.

The Potbox is powered from the RUN ignition wire and provides a 2 wire communication to the Power
Center.

Unlike some controller systems on the market that have 'hot wired' components of the system outside the
controller case, this configuration provides full isolation between the 12V vehicle battery and the High
Voltage battery pack with an optocoupler interface, eliminating any possible contact with the High Voltage
pack.
Customer Installation Ideas